Saltvandsforum.dk

4) Input pipe came off, it had been a bit damp and I thought surely this won't come off as it should be all designed for each other. Bad idea leaving. Where on the input the drip adjuster the tube that connects it to the main unit came off. Water every where. Looking at it in detail after it was never suitable for the job. To show how the black pipe is I put another pipe of a smaller diameter inside and it pushed on to the main unit and drip adjuster fine. I have also zip clipped it as well to make sure it doesnt happen again.



Deltec fit the reactors with 5-8mm silicone hose and the units have always been supplied like that. The pipe is fairly hard to pull off and remove. To this the orange water flow control tap is fitted. You then fit your chosen feed pipe to it. Again Deltec supply both nitrate and calcium reactors this way and have done so for years. I would recommend cable ties on all soft pipe fittings. This is not just Deltec equipment but all soft pipe fittings on any piece of equipment used.

Stephensen skrev:Det er med motor på.